The Rx35 is a 4 channel receiver unit for use with micro servos like the BioMetal or Linear servos. It has no connectors onboard so you are able to solder your servo wires directly to the board and save weight. Alternatively, you may solder your own Molex or JST ZH connector sockets.
This is a DSM2 compatible receiver unit which can be bound to a Spektrum DSM2 capable transmitter or any other transmitter which is DSM2 capable. It also has a 2 Amp brushed ESC onboard.
The 4 channels with PB connectors are for Throttle, Aileron, Elevator and Rudder. additional channels for Gear and Aux signals can be soldered direct to pads on the underneath of the circuit board. If you are using an external ESC, you can connect it to the Throttle connector.
MicronWings recommends this unit for builders who are experienced in micro soldering and need to customise their unit to minimise weight.
 |
This example from the Edge 540 build log shows the DTrx35 receiver unit in use. Note that in this setup the power is supplied to the trceiver unit via the two black and red leads which are soldered directly to the throttle servo pads (pos and neg). You can also see the servo wires for the aileron and elevator soldered directly to the pads. |
|
|
|