About | Contact |Postage |Payment Options | Newsletter| Terms and Conditions|

Motor D1103 8200kv Brushless
0101Image01 0202Image02 0303Image03 0404Image04 0505Image05 0606Image06


Length 16.2mm
Can Diameter 13.7mm
Weight 3.3 grams
KV 8500kv
Shaft 1.5mm
Voltage 1S 3.7V
Lead length 60mm
1 x Motor
1 x Motor mount
4 x Motor mount screws
4 x Mounting screws

This motor provides a very good thrust to weight ratio. It is rated for 1S (3.7 volts) only and supplied with the motor mount detached. You will need a fine tip screwdriver for the screws that attach the mount.

MicronWings Test Data
Prop   Thrust ESC Volts
GWS 2510 EP 26 Grams 3A 1S ESC 4.0 Volts
GWS 3020 EP 36 Grams 3A 1S ESC 4.0 Volts
90mm EP 34 Grams 3A 1S ESC 4.0 Volts
80mm White Prop 33 Grams 3A 1S ESC 4.0 Volts
GWS 4025 EP 45 Grams 7A 1S ESC 4.0 Volts

When using the three props shown below with this motor,
you will need to drill out the prop bore to 1.4mm.

When using a GWS4025 prop you will need to use a 1S (3.7volt) ESC which is capable of supplying over 3 amps.
Note: The GWS 4025 is the largest prop which can be used with this motor. Any larger props including the GWS 4040 EP will draw too much current for this motor.
This 7 Amp ESC is the best choice if you are using a GWS 4025 prop. This ESC can run on 1S (3.7 volts) and supply over 3 amps.
Propeller Adapters 1.5mm
These prop adapters have a 1.5mm bore and are suitable for the GWS 4025 prop. Use these adapters for smoother operation in situations where prop strike is not likely.
Prop Saver 1.5mm Alloy
This prop saver is suitable for use with the GWS 4025 prop and will guard against damage in the case of prop strike. Prop balance may not be as accurate with a prop saver compared to a prop adapter.


Price: $29.00


Related Items
1 2510 prop
1 3020 prop
1 4025 prop
80mm White Prop
90mm Prop
5043 prop
6030 carbon 1.5mm Adapter
ESC Micro 3A ESC
motor spacers Mount Spacers