ESC Micro MX-3A


19.90 AUD

(pack of 10)

Out of stock

The Mx-3A is the new standard in micro ESC units. Power can be supplied directly to the ESC via the two Pos and Neg pads on the board, eliminating the need to separately power the receiver.

Firmware Version: SuperMicro 3.5A (BlheliS 14.9)
Revision: 14.9


Length 13mm
Width 11.5mm
Height 3.4mm
(including wires)
0.37 grams
Battery 3.7 volts
Current 3A
Burst Current 5A (5 sec)


Wiring Example


Changing ESC Settings
The settings on this ESC can be changed using the BLheli S Configurator.
You can download the configurator from the BLHeli Google Drive
Be sure to download BLHeliSuite – not BLHeliSuite32

Install the BLHeli software (the interface should look like the images shown below)
You will also need a USB Linker card like the one shown in the image below. You can purchase various versions these online but they are all wired up a similar way.

Wire up your ESC and USB linker as shown here.

Connect to the ESC and change settings as necessary.

The image below shows the default settings for this ESC