Receiver MA-RX42E-F2+ FrSky D16 Telem Brushless 5A ESC

Price: 

42.60 AUD

8 in stock

Specifications:

Modulation FRSky D16
Length 22.5mm
Width 11.8mm
Height 6.6mm
Weight 1.2 grams
Connector JST SH
ESC 5 Amp 1S
Voltage 1S – 3.3-4.2
Channels 5

This receiver is designed for 1S (3.7 volt) operation. It has an on-board 5Amp 1S brushless ESC and SMD holes in the board large anough to accept either of the two included connectors. Alternatively, motor wires can be soldered directory to the board.

This D16 version supports telemetry and can be used with any FRSky transmitter which supports the D16 protocol. The latest transmitters from FRSky which use the ACCESS protocol can also bind to this receiver under D16 mode.

This receiver can be programmed with this Receiver Programming Tool

Dual Aileron Mode
By bridging the pads underneath the board marked “P” the CH5 port will function as the second reversed aileron port making dual aileron setup very easy with no transmitter programming necessary.

Binding
Connect the battery to the receiver and after 15 seconds the LED will blink fast. Then turn on your transmitter and put it into bind mode to complete the bind process.

Telemetry Function
This receiver is capable of sending back telemetry information to the transmitter. Signal Strength (RSSI), Battery Voltage (being supplied to the receiver) and Temperature Data can be sent back. Please note that typically telemetry reception distance is not as great as the receiver’s maximum range distance.