Servo Mounts for 5320 and 5330 Servos

Specifications:

Using servo mounts can save you time and money. These servo mounts are glued to your airframe and instead of gluing servos to the airframe, you simply screw them to the mounts. This way, you can easily swap out and replace a broken servo and easily remove servos from a decommissioned airframe without having to remove glue from the servo.

Cut the tab attaching the servo mounts and remove from the sheet.

You may need to use a needle or fine drill to open the holes a little.

Opening the holes up is only necessary if using the machine thread screws supplied with the 5320 / 5330 servo (on left in image velow). We however suggest that you use self tapping M1.4 x 4mm Screws for best results (on right in image below).

Place on airframe and mark out the servo hole which needs to be cut out of the airframe.

Cut the servo hole out.

Glue the servo mount to the airframe. UHU POR Expanded Polystyrene glue is good.

Mount the servo