Adapter JR to JST SH
Price:Â
12.50 AUD
(pack of 4)
5 in stock
Specifications:
| Weight | 0.71g each |
| Length | 48mm |
| Connector 1 | JST SH |
| Connector 2 | JR / Futaba |
| No in pack | 4 |
Adapters for JR / Futaba to JST SH.
This adapter is designed to be used to connect a micro servo to a standard JR / Futaba receiver unit. Please be aware that standard receivers when powered by an ESC with BEC, run at 4.8 volts but some micro servos may not be suitable for this voltage and only run on 1S (3.7volts).
| The servos below can be connected to a standard receiver with this adapter. Please see the notes specific to each servo. | |||
 |
Servo Micro Black 2gram With JST SH Connector Maximum Operating Voltage:Â 5 volts (use for ESC with BEC power to Rx) Polarity:Â Negative and signal wire must be swapped on the servo plug |
||
 |
Servo Linear Origin Mi-LSM 1300S Maximum Operating Voltage:Â 4.2 volts (Use 1S voltage to power Rx) Polarity:Â Negative and signal wire must be swapped on the servo plug |
||
 |
Servo BlueArrow S02512 Maximum Operating Voltage:Â 6 volts (use for ESC with BEC power to Rx) Polarity:Â Negative and signal wire must be swapped on the servo plug |
||
